ASTM B505 PDF
ASTM B BM 08 Standard Specification for Copper Alloy Continuous Castings_机械/仪表_工程科技_专业资料。ASTM B BM Chemical Composition according to ASTM B/BM 1Ni value includes Co. Note: Cu + Sum of Named Elements, % min. Single values, unless. ASTM B/BM Standard Specification for Copper Alloy Continuous Castings. standard by ASTM International, 03/01/ View all product details.
|Published (Last):||5 November 2004|
|PDF File Size:||10.33 Mb|
|ePub File Size:||20.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
Link to Active This link will always route to the current Active version of the standard. They are a combination of the calculated theoretical weights and an average of actual weights. Approved April 1, The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. C tin bronze 89 For sampling purposes, a lot shall consist of castings of the same composition and same cross-sectional dimensions, produced during the continuous operation of one casting machine, and submitted for inspection at one time unless specified otherwise.
Cooling shall be by the fastest means possible that will not cause excessive distortion or cracking. Weld repairs may be made at the manufacturer’s discretion. It just another part of value we offer at Morgan.
Each continuous cast bar from which the test bar was taken shall be identi?
It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. D Yield strength at 0. Dimensions and Permissible Variations This leaded tin bronze, alloy C can be produced in 3 ways, continuous cast, centrifugal cast, or sand cast.
ASTM B505 SAE 660 Bronze
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The Physical, Fabrication and Thermal Properties shown here represent reasonable approximations suitable for general engineering use.
When castings are produced from alloy ingots of known composition, the sampling interval may be raised to one sample for each lb kg of continuous production of the lot. A number in parentheses indicates the year of last reapproval.
F Chromium b055 shall be 0. Combining values from the two systems may result in non-conformance with the speci? Applicable to any longitudinal surface or edge. Residual elements may be present in cast copper-base alloys. This sample may be taken before mechanical straightening. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
When tolerances are speci?
C, C, C, and C may be supplied in the heat-treated condition to obtain 4 the higher mechanical properties shown in Table 9. The suffix can be used to accommodate composition variations of the base alloy. C nickel-tin bronze No further reproductions authorized. C leaded semi-red brass 76 2. This standard has been approved for use by agencies of the Department of Defense.
ASTM B / BM – 18 Standard Specification for Copper Alloy Continuous Castings
This standard is subject to revision at any time by the responsible technical committee and must be reviewed every? Analysis shall be made for residual elements only when speci?
The derived SI unit for force is the xstm Nwhich is de? Specifications shown are current as of May 4, The weights listed are the best estimates of the actual weights we will ship.
Newsletter Sign Up Email.
Active view current version of standard. Combining values from the two systems may result in non-conformance with the standard.